Digitronic
CamCon Terminal
Automationsanlagen GmbH
DC51/T
4. Commisioning
Please check the wiring before activating the device for the first time. See chapter "3.1. Pin allocation
of the CamCon Terminal" on page 5.
After being switched on the CamCon will generate a short tone. Afterwards it will start the internal
review and the running up of the system (e.g. to generate the proof total of the EEPROM and the
EPROM). This process takes several seconds. After a successful istallation of the system, the
CamCon Terminal tries to establish contact with the cam controller that it communicated with before
the last deactivation. If this cam controller is found, the CamCon Terminal displays the cam controller'
s main menu on its screen. "
No contact with unit XX !
" is displayed, if this cam controller is not found
( XX stands for the unit number of the cam controller ).
5. Operation of the CamCon Terminal
5.1. The main menu
After the activation of the supply voltage, the terminal tries to make contact with a CamCon cam
controller. If this fails, the device displays the following message after 5 seconds:
You return to the main menu by pressing the
key
once. The text "CamCon Terminal", as well as the unit
number, is displayed in the top line of the main menu.
Attention:
The unit - or device numbers may only be
allocated once on an CamCon RS485 BUS.
Main menu CamCon Terminal
The main menu is the starting point of the operation. You
can select the desired menu by pressing the corresponding
numeric key, or by moving the black beam on the desired
menu point with the keys
and
and confirming your
selection with the
key.
Main menu CamCon cam controller
If contact is made to a CamCon cam controller afer
activation, its main menu is displayed. The upper righthand
corner of the display shows the unit numberof this cam
controller. This number is e.g. 1. To break the connection
from cam controller to the Terminal, leave any current
submenu of the cam controller by pressing the
key.
When you are in the main menu, press the
key for about
2 seconds, and you return to the main menu of the CamCon
Terminal. Here you have the possibility to select four submenus. In the submenus 2, 3 and 4, you can
always return to the main menu by pressing the
key once. Menu 1 can be left only by holding the
key pressed for about 2 seconds. The following chapters describe the different menu points and
their functions in details.
Version: Jul. 04
Page: 7
2 rue René Laennec 51500 Taissy France
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
E-mail:[email protected]
Site web : www.hvssystem.com
