SETTING BASIC DATA
12
ENTRY OF WORKING WIDTH
Seeding machine working width is adjustable between 0.75-30 metres
This constant is needed for area count.
Working width can be calculated: row number multiplied by row spacing.
100 SPEED SIGNAL COUNT
This is a side function to get information about distance traveled in 100 speed
signals.
Pull/tow seeding machine on field until 100 speed signals are counted, then
measure distance traveled between 0. and 100. signals with a measure
tape
on the ground. Enter distance value in the monitor in centimeters. A
warning beep
sounds from 90. speed sensor signal to slow down.
Speed sensor is an inductive sensor which detects bolt heads of a driven
wheel.
In case of individual installation the number of signalling bolt heads must be
enough to provide at least one signal at
every 30-60 cms distance traveled
and it may not exceed 100 cms.
Readiness for operation
is indicated by a flashing
SPEED SENSOR LED
on
the monitor. Accurate measurement can be reached if
speed sensor exactly
aligns bolt head
when starting calibration. Besides signal counter on screen
watch this red LED
as well, which shows you how sharply the sensor aligns
the bolt head, both at start and end points.
Measurement of distance traveled between 0-100. speed signals:
J
X
>
TU
<
J
|? 4.50 m
J
Y
>
Spinner up & down
TU
100|
Ü
------------|0
START>
TU
100|
Ü
------------|0
START>
TU
100|
Ü
------------|0
100
START>
0.
90.
100.
Nomber of speed
signals =
Distance travelled = ??? cm
Csavarok
wheel sensor
START
SLOW DOWN
STOP
