User Manual
NOTE. Each flat is delivered with an appropriate manufacturer PIN code – 1234. Change it, otherwise doors
unlock code and new identificator programming function are unavailable.
1. How to use a door phone:
For connection with a subscriber enter his/her flat number (from 1 to 9999) and press
ENTER
(otherwise
call will be started automatically after 3 sec). Should a mistake appear or for canceling your call press
CANCEL
.
Conversation starts upon subscriber’s, whom you are calling to, answer. During the conversation the subscriber could
unlock the doors using a button on audio handset.
Door unlock delay
time is programmed during system installation and does not depend on duration of pressing the
unlock button.
Unlock button functions only within a handset, the call was addresses to, and only in 2 sec after subscriber’s answer.
Duration of a call and a conversation is limited to 1 min and 2 min accordingly. After this term finishes, the system
returns to duty mode.
In case a door was unlocked with your PIN code, a handset will shortly peep 3 times.
Handset
’s switch on/off button allow to switch the receiver off.
2. Entering from outside
There are two ways of unlocking a door externally:
•
Using TM identificator *
Attach TM key to a reader. If the key is suitable (added to a door phone memory**), the door unlocks. A
rank number of your key and a note “OPEN” appear on a display shortly with a sound signal. In case an
identificator is related to a flat, a sound signal (informing on door unlock using an electronic key) will be
sent to an handset.
•
Using RFID identificator *
Attach RFID identificator to a door phone display ( reader antenna is mounted within) . If the identificator is
suitable (added to a door phone memory**), the door unlocks. A rank number of the identificator and a note
“OPEN” appear on a display shortly with a sound signal. In case an identificator is related to a flat, a sound
signal (informing on door unlock using an electronic key) will be sent to an handset.
•
Entering a door unlock code
A door unlock code consists from a flat number ID, a keyboard symbol “*” and an individual 4-digits code
(XXXX)-ID*XXXX. For 4-digits code programming see “Set/change users door unlock code”, page 24, or
User’s Manual, below. After entering a right code using a keyboard, the door unlocks. A note “OPEN”
appears on a display with a sound signal of the door phone and an additional sound signal (informing on
door unlock using individual code, related to the flat) will be sent to an audio receiver.
•
Doors could be unlocked by the person you are calling to during the conversation
In order to come indoors, a person (a guest) could call to any flat. During the conversation other person by
the handset has a possibility to unlock the door*** and let the guest in. to unlock the door is possible after 2
sec from the beginning of the conversation. For unlock the door, press a button within the handset without
hang up. Door could be unlocked using the handset, a call is addressed to, during the conversational
session only.
3. Internal door unlock
To unlock the door from inside the building press an unlock button, placed indoors, near the door.
4. Changing of user’s PIN code:
NOTE. Each flat is delivered with an appropriate factory PIN code – 1234. Change it, otherwise doors
unlock by code is unavailable.
For changing PIN code two persons are necessary: one staying outdoors near a outdoor panel, other – indoors by
the handset.
1. Enter a flat number, press
and wait till a person indoors answers.
2. Press and hold
. A person indoors should press a door unlock button for three times (each second).
3. Four dashes will be shown on a display. Enter an old (or factory) PIN .
4. A word “PIN” flashes and four dashes are shown on a display. Enter a new PIN.
37
ENTER
