Installation Using Surface Mount Bracket
Installation -
Drilling the Hole
on the Ceiling
Connecting the Cables and
the Terminal Block
Fixing the Main Body
Detaching the Protection
Film
Fixing the Surface
Mount Bracket
2
2
1
3
4
5
2
1
5
3
4
Rubber Gasket
Template Sheet
Disassemble the main body with the surface mount
before installation the camera.
Drilling a Hole on the Ceiling
Using provided template sheet, drill a hole (30mm
diameter) on the ceiling panel to pass cables.
Fixing the Surface Mount Bracket
Pass the cables through the ¾” pipe hole, and screw
the surface mount bracket to the ceiling.
Rubber Gasket
- Before installing the gasket, the hole in the center is
to be cut by knife when only necessary.
Connecting the Cables and the Terminal Block
Connect the cables to the terminal block and then
put the terminal block in the slot of the main body.
(See the section ‘Terminal Block’ for details.)
Fixing the Main Body
Screw the main body to the surface mount bracket by
screwing 4 lock-up screws.
Detaching the Protection Film
Detach the protection film from the dome cover after
finishing all installation.
11