Digital Projection
Titan Laser Series
Rev A January 2019
Page 23
Important Information
Switching the projector on
1. Connect the power cable between the mains supply and the projector. (See
Connecting the
power supply
above.) Switch the breaker switch next to the power connector to on.
The
POWER
indicator turns red to signal that the projecter is on and in STANDBY mode.
2. Press one of the following buttons:
•
On the remote control, the
ON
button
•
On the projector control panel, the
POWER
button.
The
POWER
indicator begins flashing green as the projector powers up. When the flashing stops,
the
POWER
indicator lights solid green and the Digital Projection logo appears on the screen. The
projector is switched on and projecting.
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to confirm
your choice.
The
POWER
indicator on the control panel will start flashing blue, the projected image will turn off
and the cooling fans will run for a short time until the
POWER
indicator goes steady red to indicate
that the projector has entered STANDBY mode.
2.
If you need to switch the projector off completely, switch the breaker switch next to the power
connector to off and then disconnect the power cable from the projector.
