Digital Projection M-Vision Cine 400 3D series, Руководство пользователя

Страница: 43 / 58

Digital Projection
M-Vision Cine 400 3D series
A TOUR OF THE MENUS Operating Guide
Revision C, July 2014
Advanced Image menu continued from previous page
Fine Sync
● V Position and H Position
Set the sliders as required.
● Phase
Adjusts the phase of the pixel sampling clock relative to the incoming
signal. Adjust the phase if noise is visible.
● Tracking
Adjusts the frequency of the pixel sampling clock. Flicker or vertical
banding indicate poor tracking.
● Sync Level
Adjusts the voltage level of the signal detection circuitry. Adjust if the
projector loses sync during scenes where the signal drops below black.
Highlight the Fine Sync setting, and then either press
ENTER/SELECT
to access it, or use the
LEFT
and
RIGHT
arrow buttons to switch
between values.
Press
MENU
to go back.
Color Mode
Use the LEFT and RIGHT arrow buttons to select from:
● Mode 1
Brightness optimized.
● Mode 2
Color optimized.
Notes
Some of the settings within the
Fine Sync
sub-menu,
Phase
,
Tracking and Sync Level , affect
only RGB and Component input
sources. These settings are not
available if the projector is using a
different source.
Adjust the Phase after adjusting
Tracking .
Op-13
H Position
ADVANCED IMAGE >> Fine Sync
V Position 100
100
Phase 100
Tracking 100
Sync Level 100