Digital Projection HIGHlite 740 1080p, Инструкция по установке и быстрому запуску

Страница: 54 / 157

page 45
Digital Projection HIGHlite 740 Series
Operating Guide
USING THE PROJECTOR
Rev I February 2015
Edge Blend menu
Overview
When several projectors are used to create a large tiled
image, the edges need to be blended to avoid the overlaps
appearing brighter than the rest of the image.
As it is not possible for any projector to produce an
absolute black, any ‘black’ areas in the overlapped edges
may appear slightly less dark than those in the rest of the
image.
Black Level Uplift
can be used to counteract this
effect, by raising the black level of the rest of the image.
The amount of uplift required will be either x2 or x4,
depending on how many images are overlapped, as shown
in the examples on this page.
Image brightness changes from one point to another,
within the same blended region. If the same level of black
level uplift is applied throughout the blended region, the
overlapping edges may still be visible on the screen.
Therefore, brightness in these areas is decreased
gradually, using an s-curve factor.
S-Curve Value
is used
to control the steepness of the decrease.
Notes
Main Menu
Edge Blend
This menu is available only when
Setup > System > Configuration is
set to
Edge Blend
.
None of the other items in this menu
are available until either the
Array
Width
or the
Array Height
setting
is greater than 1 .
For a detailed step-by-step
description of the edge blend
process, see
Blending images
from multiple projectors further in
this section.
Two projectors sharing one overlapping edge
1 2
1
x2 uplift area
2
no uplift
Four projectors with overlapping edges
2 1 3
1
x4 uplift area
2
x2 uplift area
3
no uplift