Digital Projection HIGHlite 740 1080p, Инструкция по установке и быстрому запуску, Страница: 19 / 157

page 11
Digital Projection HIGHlite 740 Series
Installation and Quick-Start Guide
POSITIONING THE SCREEN AND PROJECTOR
Rev I February 2015
Positioning The Screen And Projector
1. Install the screen, ensuring that it is in the best position for
viewing by your audience.
2. Mount the projector, ensuring that it is at a suitable distance
from the screen for the image to fill the screen. Set the
adjustable feet so that the projector is level, and perpendicular
to the screen.
The dimension drawing below shows the positions of the feet for
table mounting, and the fixing holes for ceiling mounting.
1 Four adjustable feet
2 Six M6 holes for ceiling mount
The screws should not penetrate more than 15 mm
(0.6 in.) into the body of the projector.
Notes
Always allow the projector
to cool for 5 minutes before
disconnecting the power or
moving the projector.
Ensure that there is at least
30 cm (12 in.) of space between
the ventilation outlets and any
wall, and 10 cm (4 in.) on all other
sides.
Do not stack more than three
projectors.
When positioning the projector,
do not exceed the roll limits
as this may cause serious
lamp failure, damage the lamp
module and cause extra cost
on replacement. For more
information, see Tilting the
projector further in this guide.
1
2
1
1
1
2
2
2
2
2