Removing Graphics Module (if applicable),
Continued
Remove the
Graphics
Module(s)
To remove the graphics module(s) from the BA46 system
enclosure, complete the following steps:
If you have
an...
Then...
LCG
1.
Release the graphics module latches and lift
the module out of the BA46 enclosure.
2.
Place the LCG graphics module on the
antistatic mat.
SPXg
1.
Release the graphics module latches on the
video board clamp. Refer to Figure 2–1.
2.
Lift the graphics assembly free of the system
module connector, and remove it from the
system enclosure.
3.
Place the graphics assembly on the antistatic
mat.
4.
Remove the video board clamp from the KA46
system module by spreading the sides of the
video board clamp away from the connector,
and then lift the clamp off and away from the
system module. Save the video board clamp for
use on the KA49 system module.
Continued on next page
2–16
