Example 4:
The expected response of a SHOW ADDRESS command for a range of addresses
appears as follows:
DECbridge>SHOW ADDRESS 2,6
Address 2: 08-00-2B-10-20-30 hub 2 slot 8 port 4
Address 5: 08-00-2B-10-6A-31 hub 2 slot 3 port 3
Address 6: 08-00-2B-A6-43-17 hub 1 slot 3 port 5
SHOW PORT [hub number,] slot number, port number
Shows whether the port is enabled or disabled and shows the operational status
of the port. Hub numbers can be 1 or 2; slot numbers can be 1 to 8. For the
DECrepeater 90T, port numbers are 1 to 8; for the DECrepeater 90C, port
numbers are 1 to 6; for the DECrepeater 90FL, port numbers are 1 to 4; for the
DECrepeater 90A, port numbers are 1 to 3.
Example 1:
The expected response to a SHOW PORT command appears as follows:
DECbridge>SHOW PORT 3,2
Hub 1 slot 3 port 2 segment counter 0 status: disabled-no carrier loopback
The hub was not defined in the command; therefore, the default (1) was used.
Example 2:
A SHOW PORT command for hub 2 appears as follows:
DECbridge>SHOW PORT 2,3,2
Hub 2 slot 3 port 2 segment counter 0 status: operational
SHOW REPEATER [[hub slot number,]slot number]
Shows the type of repeater and the port status for each port on that repeater.
The hub number can be 1 or 2, and slot numbers can be 1 to 8. If you do not
include parameters, information is shown for all repeaters in both hubs.
4–10 Managing the DECrepeater 90FA