Digital Electronics Corporation Pro-Face PL-6900 Series, Руководство пользователя

Страница: 76 / 105

System Setup
5 - 15
PL-6900 Series User Manual
„ „
„ „ „
IDE Primary Master UDMA
Designates the Master Drive's UDMA Operation Mode. The two
selections available are [Auto] or [Disabled]. The [Auto] selection is
factory set and recommended for most users.
„ „
„ „
„
IDE Primary Slave UDMA
Designates the Slave Drive's UDMA Operation Mode. The two
selections available are [Auto] or [Disabled]. The [Auto] selection is
factory set and recommended for most users.
„ „
„ „
„
Onboard FDC Controller
Designates whether the PL's FDD(Floppy Disk Drive) controller is used or
not. The two selections available are [Disabled] or [Enabled]. The
[Enabled] selection is factory set and recommended for most users.
„ „
„ „
„
Onboard Serial Port1
Designates the PL's Serial Port1 address setting. The selections include
[Disabled], [Auto], [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4] or [2E8/IRQ3].
The [3F8/IRQ4] selection is factory set and recommended for most users.
„ „
„ „
„
Onboard Serial Port2
Designates the PL's Serial Port2 address setting. The selections include
[Disabled], [Auto], [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4] or [2E8/IRQ3].
The [2F8/IRQ3] selection is factory set and recommended for most users.
„ „ „ „ „
UR2 Mode
Designates the IR function used by the PL's onboard I/O chip. The selections
include [Standard], [Sharp IR], [IrDA SIR]. The [Standard] selection is
factory set and recommended for most users. When serial port 2 is used for
RS-232C communication, and the [standard] option's PL-IR100 selection is
used, set this item to [IrDA/SIR].
„ „
„ „ „
Onboard Parallel Port
Selects the PL Parallel Port 1's I/O Address. The selections include
[Disabled], [3BC/IRQ7], [378/IRQ7] or [278/IRQ5]. The [3BC/IRQ7]
selection is factory set and recommended for most users.
„ „
„ „ „
Parallel Port Mode
Here, the parallel port's operation mode can be selected ([SPP], [EPP1.7],
[EPP1.9], [ECP], or [ECP
+
EPP]). Normally, [SPP] is used and
recommended for most users. When either [ECP] or [ECP+EPP] is
selected, the [ECP Mode Use DMA] setting can be used.
„ „
„ „ „
ECP Mode Use DMA
Designates the ECP mode's DMA channel. [1] and [3] are available
selections, however, this item can be set only when the Parallel Port Mode
is set to either [ECP] or [ECP+EPP].
„ „
„ „ „
Onboard Serial Port 3
Designates the PL's Serial port 3 address setting. The selections include
[Disabled], [3F8H], [2F8H], [3E8H], or [2E8H]. The [3E8H] selection is
factory set and recommended for most users.