Page 17
Please read the instructions carefully prior to installation
DGHDP1 -
DigiSender® HD Pro - 1080p Powerline AV Sender System
Advanced Procedures
Transmitter & Receiver Syncing
The
Transmitter & Receiver Syncing
procedure should only be used when installing an Additional Receiver or
during Troubleshooting.
There are two ways in which the Transmitter and Receiver can be ‘Synchronised’ or ‘Synced’:
• ‘Sync’ using the buttons on the Transmitter and Receiver:
1. Press and hold the
Group Button
on the rear of the Receiver until the message
“SYNCING”
is
displayed on the receiving TV.
2. Press and hold the
Group Button
on the rear of the Transmitter for 2 seconds until the
Sync and
Power LEDs
blink sequentially.
If the Sync is successful, the message on the receiving TV will change from
“SYNCING”
to
“SYNCED”
,
followed by the video (providing that the source device is currently on and media is playing).
• ‘Sync’ using the remote control:
Press the
Group Button
on the DigiSender® remote control to sync the Transmitter and Receiver.
Note:
It is highly recommended that you perform the above procedure with both the DigiSender® Transmitter and
Receiver in the same vicinity, preferably attached to the same dual-socket mains power outlet.