DIGIQUEST
10
If you have a standard, fixed installation with a single LNB, do not make any changes,
go to
FORWARD
and press
OK
.
If you have a system with SCR LNB (SCR illuminator, e.g. Sky My Sky HD system) or
dCSS (e.g. Sky Q system) change the settings as shown below:
- Satellite:
Hotbird 13° East.
- LNB:
Universal.
Antenna type:
select the type of LNB (illuminator) you have (SCR or dCSS). In the
window that appears (SCR or dCSS Status) select On. Choose a free slot (port or
channel), i.e. not already used for Sky decoders or similar (if you do not know it, you
can proceed by trial and error, until the channel search is successful). Automatically
will vary also the FREQUENCY DCSS or SCR voice since it is connected by default
to the chosen port.
- LNB POWER SUPPLY:
On .
Once the desired parameters have been entered, go to
FORWARD
and press
OK
.
In the
CHANNEL SEARCH
:
Satellite
, choose the desired one.
Transponder
, choose the one you want.
Search type
: you can start searching for
Tivù (Tivusat) + free-to-air, Tivù, Tutti
.
By default the search type is set to Tivù + unencrypted, but it is possible to select only
Tivù: the decoder will search only the channels belonging to the Tivùsat package and
therefore the search will be faster.
Move to
FORWARD
and press
OK
. The search for satellite channels will start.
Once the scan is complete and you have searched for any available SW updates,
press
OK
, you will enter the window relating to the
TIVÙSAT SMARTCARD
. Insert
your card in one of the two available slots, the chip must be facing downwards: for
activation follow the instructions in the card manual or follow the instructions that will
appear on the video. If the card is already activated, just go to
FORWARD
and press
OK
.
TERRESTRIAL
After you have loaded the satellite channels, to load the terrestrial ones: press
MENU
,
with the ◄ or ► key go to the Installation menu, with the
▼
key go to
Auto Scan
Digital Terrestrial
and press
OK
. Always confirm with
OK
to start the automatic scan
for terrestrial channels. You can exit the scan at any time by pressing
OK
on the
remote control. At the end of the channel scan, a channel positioning conflict may
occur: in this case a window will appear listing the channels found on two or more
different frequencies. If the position proposed by the decoder is the desired one, just
wait without pressing anything. If you want to change the channel to be stored, use
