Digi PortServer II, Руководство пользователя

Страница: 155 / 277

90030500B Configuring Modem Connections Page 135
A script to initialize a Hayes-compatible modem
The following script initializes the modem and sets the data speed for 115.2Kbps. If
the modem does not initialize correctly, it prints setup failed, otherwise it prints setup
succeeded.
s1=”M{at\r} [OK} s3 T4”
s2=”M{at$k1&y0&f\r} [OK]3 T4”
s3=”M{at13&d3$B11520m1s0=1s2=0s11=50*w\r} [OK]5 T4”
s4=”E{setup failed} G-”
s5=”E{setup succeeded} G+”
A script to test a specific modem
The following script tests a Microcomm DeskPort Fast modem and connecting cable.
Note: If you are using the
altpin
option, temporarily disable it using the
set flow
altpin=off port=<number>
command, otherwise the test will fail.
s1=”C0 F M{at&f\r} [OK]2 S5 T3” //no hangup, flush, set modem to
//factory defaults, wait for OK
s2=”T4 W-1 T5 W+2 G6” //wait for DCD low, CTS high
s3=”E{Error Condition} G-” // s1 didn't get OK, or other
//error
s4=”E{DCD stuck high} G-”
s5=”E{CTS stuck low} G-”
s6=”M{at\\q0 \\d2 \r} T7 W-2 G8” //no flow control, CTS follows
//DCD, detect CTS low
s7=”E{CTS stuck high} G-”
s8=”M{at &C0 \\d0 \r} T9 W+1 G10”//DCD on, detect DCD high
s9=”E{DCD stuck low} G-”
s10=”M{at &f\r} {OK}11 S5 T3” //reset to factory defaults
s11=”M{at &d3s0=7so?\r} [7]12 T3” //dtr transition clears
//modem, set so=7, read so
s12=”D-1 P2 D+1 M{at so?\r} [0] 14 T13”//raise and lower dtr to
//clear modem, s0 goes to 0
s13=”E{DTR undetected} G-”
s14=”M{at &f\r} E{Cable test complete} G+”
To run the script, enter the following commands:
set port devtype=mout range=port#
set modem test=testmicrocom range=port#
wan testmodem=port#
If the test is successful, it will display “Cable test complete”.