Advanced configuration with aView
Terminal on unit
Digi 5400-RM Cellular Remote Manager User Guide
29
Setup
For this setup, you need access to aView and a Digi 5400-RM online and syncing with aView. If you see
the Digi 5400-RM listed as up (green status) in aView, you are good to go.
Details
Note
aView uses the IPSec tunnel the Digi 5400-RM establishes to
remote.accns.com
to provide
terminal access to the console of the Digi 5400-RM. For details on the monthly data usage for this
access, see
The following configuration sets up the Digi 5400-RM to report its IPSec tunnel local IP address as the
management IP that aView can then use to access its console.
Open the configuration profile for the Digi 5400-RM. Under
IPSec -> aView
, set the
Management
priority
to
10
. This gives the aView IPSec tunnel the highest priority management interface, which it
then reports to aView as the IP that can be used to access its console.
Once you apply the new configuration to the Digi 5400-RM, reboot the device so it rebuilds the IPSec
tunnel and reports the new IPSec local IP address to aView. You can verify that aView is using the
IPSec local IP as the management IP by looking at the
Uplink IP address
on the
Device Details
tab.
This value should be set to a
172.x.x.x
IP address.