Advanced configuration with aView
Establishing WAN connectivity via Ethernet port
Digi 5400-RM Cellular Remote Manager User Guide
27
single IP address will be available through the device’s Ethernet port. Only one client device can be
connected to the Digi 5400-RM through its Ethernet port at a time.
1. Log into the aView management portal and use the search bar to filter devices by
MAC
address
.
Note
The device MAC address is on its bottom label.
2. Click the MAC address of your Digi 5400-RM device to bring up its
Details
page.
3. Select the
View Configuration
link in the
Configuration
section of the page.
4. Once viewing the configuration profile, select the
Edit
pencil icon at the top right of the page.
5. Open
Network > Interfaces > LAN
6. Check
Enabled
.
7. For
Interface type
, select
IP Passthrough
.
8. If
Device
is set to a bridge:
a. Click the
Device
drop-down.
b. Select a specific LAN Ethernet port that the client device will be connected to in
order to receive the passthrough IP.
When passthrough mode is enabled for an interface, it will only provide one DHCP IP
address to the client device connected to that port. This means only one client
device can be connected to the LAN port of the DAL device at a time, because it will
only have one passthrough IP to provide at any given point.
9. Select the interface(s) that will provide the IP address to the client device connected to the
LAN port:
a. Click to expand
Source interfaces
.
b. Click
Add
.
c. For
Interface
, select an appropriate interface.
Typically, this will be the
Modem
interface, but additional interfaces (such as the
WAN interface) could be included.
d. Repeat to add additional interfaces.