Physical installation
Default settings
Digi 5400-RM Cellular Remote Manager User Guide
16
Default settings
Option
Default settings
Interface
priorities
n
LAN set at a metric of 1.
n
Modem (cellular) at a metric of 3.
Network
settings
n
LAN port configured as primary Internet interface.
n
LAN port configured to obtain IP address via DHCP.
n
Cellular modem configured as backup Internet interface.
n
Source NAT enabled (outbound traffic).
Modem
settings
n
Carrier SmartSelect enabled.
n
Passthrough mode disabled.
n
APN fallback enabled.
Central
management
settings
n
Central Management using aView enabled. The following servers will be
contacted for a central configuration:
l
aview.accns.com
l
armt.att.com
l
av-wob.gcsc.att.com
Security
policies
n
Packet Filtering set to block all inbound traffic.
n
Local SSH, Web Admin, and Local GUI access enabled at the 192.168.210.1 IP
address. See
for details on accessing the Digi 5400-RM via
its default 192.168.210.1 IP.
Serial ports
n
All four serial ports enabled with the same default settings:
l
Baud rate: 9600
l
Data bits: 8
l
Parity: none
l
Stop bits: 1
l
Flow control: none
Connecting to the site network
To use your wired network as an alternative network to access the devices connected to the Digi
5400-RM serial ports, connect the LAN port on the Digi 5400-RM to your site Gateway. By default, a
DHCP request will be sent to the local Ethernet network.