Dietz 9403-A, Инструкция по эксплуатации

Страница: 20 / 48

Instructions for use Bath seat
20/48 8.03.2010 / Rev. 02 GB
T
e
ch
.A
u
t.
L
e
b
h
e
rz
5. Use
5.2
Adjusting the bath seat
The bath seat must be adjusted to the width of the bath tub. This is achieved by
means of the adjustment devices on the underside of the seat.
Illustrative photo
– we reserve the right to make technical changes
Remove the nuts from the four hexagon bolts with an SW4 Allen key.
Place the bath seat in the bath tub and pull both sides of the support frame until the
rubber ends are sitting completely on the rim of the bath.
Ensure that both sides are extended to the same width.
Take the bath seat out of the tub and tighten the four nuts again.
5.2 Installing the bath seat
The bath seat can be used in any standard bath of normal dimensions. The ends of
the support frame have non-slip rubber casings (1). This prevents the seat from
sliding along the rim of the tub.
Place the bath seat in the tub so that the ends of the frame sit completely on the edge of
the bath.