V3.01.51
8
d) Connect USB cable to available USB port on PC and to Repeater
e) Lower left corner of WiZARD2.4 software
will read “USB Device Attached”
followed by “Logger Update Mode”
Note: If you get a
“USB Device Not Recognized” pop up. Go to USB
Device Not Recognized in the Troubleshooting section of this
manual.
f) The Add Logger/Repeater window will open
g) The Repeater installation screen is the same as the Logger installation
screen but only requires the following information:
h)
Connect Via:
Tells the Repeater where to forward data. Select Receiver
or any installed Repeater.
i)
Name:
Any name you wish to give the Repeater: Alpha/numeric field 15
characters.
j)
Unit ID:
Enter any unique ID you wish (4 digits only (0-9 and A-F)
i)
Note:
“0000” and “FFFF” are not valid ID’s
ii) Each Repeater/Logger must have a unique ID
k)
Location:
Description of where Repeater is to be placed: Alpha/numeric
field 20 characters.
l)
Status:
Active
m) Once screen is complete click on SAVE CHANGES AND START button.
n)
A window will pop up “Adding Repeater”.
o) DO NOT disconnect Repeater until the Info window opens indicating that
the Repeater was installed successfully. This may take up to a minute
depending on the PC.
p) Once installed the Receiver will begin an Update routine for the Repeater.
Do not plug in another Repeater/Logger till the update is complete.
q) Keep the Repeater at the desk until all Loggers and Repeaters that will be
connected to it have been added.
r)
NOTES:
i)
When moving the Repeater to its target location do not turn it off.
Allow the Receiver to run on battery power while in transition.
ii) Once in the target location the Repeater will always require power
directly from the AC adapter. Batteries are recommended for backup.
iii) Repeaters
can be setup in a “chain” to extend Logger distance from
the Receiver.
5) Logger Installation (WT400/420/440/WH420/425/445)
a) Slide toggle switch to the ON position.
b) LED will flash red/blue/green for 2 seconds.
c) Connect USB cable to available USB port on PC and to Logger
d)
Lower left corner will read “USB Device Attached” followed by “Logger
Update Mode”
NOTE:
When adding USB devices many PC’s will prompt you to reboot the
PC once the device is added. Respond NO to this message. Do not reboot
the PC unless WiZARD2.4 Software has been closed first.
