2 5
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents!
Users of the SpeediCut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a Diamond Products service center.
General
Entire SpeediCut
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Cutting disc
Inspect regularly for damage and wear.
6
Clutch
Have inspected at a service center.
Protection hood
Clean
Before each start
Cutting disc
Inspect for damage and make sure the cutting wheel is
6
right for the job
V-belt
Check V-belt tension
13
(note: tension gauge must be purchased separately)
Combination switch,
Functional check
Safety locking button,
Functional check
Throttle lever
Functional check
15
Fuel tank cap
Check for tightness
Every day
Air filter
Clean
19
Idle speed
Check (cutting disc must not turn on idle)
17
Every week
Fan housing
Clean to ensure proper air cooling
11
Starter cable
Check for damage
21
V-belt
Check V-belt tension, inspect for damage and wear
18
Paper cartridge
Clean
20
Spark plug
Check and replace if necessary
20-21
Muffler
Check tightness of mounting, clean spark arrester screen
11, 24
Every 3 months
Suction head
Replace
21
Fuel tank
Clean
Annually
Entire SpeediCut
Check at an authorized service center
Storage
Entire SpeediCut
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Cutting disc
Remove and clean
12
Fuel tank
Empty and clean
Carburetor
Run empty
Page
Service, spare parts and guarantee
Maintenance and repair
The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a Diamond Products service center for all work not described in this instruction manual.
The Diamond Products service centers have all the necessary equipment and skilled and experienced personnel, who can work out
cost-effective solutions and advise you in all matters.
Please contact your nearest service center, who will gladly provide you with the address of your nearest Diamond Products service
center.
Spare parts
Reliable long-term operation, as well as the safety of your SpeediCut, depend among other things on the quality of the spare parts used.
Use only original Diamond Products parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materials,
dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions and function.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original Diamond Products spare parts are used, this will automatically invalidate the
Diamond Products product guarantee.
We will furthermore not accept any liability damages arising from the use of non-Diamond Products spare parts.