1 2
Place the spring washer (8) on the arbor and insert the screw
(C/9) and tighten by hand.
Slowly turn the cutting disc until the stop hole of the V-belt
wheel is visible in the drive-arm hole (10).
Insert the Allen key (2) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (1)
NOTE: Tighten the screw firmly, as otherwise the cutting wheel
may slip during cutting.
A
D
8
1
2
10
PUTTING INTO OPERATION
CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the SpeediCut! Always wear
protective gloves!
CAUTION:
Start the SpeediCut only after complete assembly and
inspection.
STOP
Mounting the cutting disc
Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 6.
Unscrew screw (9) and remove the spring washer (8).
Place the cutting disc (5) on the arbor (7).
CAUTION:
When using a diamond cutting disc be sure to mount it
so that it rotates in the proper direction!
For the the following work, use the assembly tools included
with delivery:
1. 13/19" AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
Place the SpeediCut on a stable surface and carry out the
following assembly steps:
B
C
1
2
3
5
5
7
7
9
8
Schematic drawing