1 5
CAUTION:
Observe the SAFETY INSTRUCTIONS on page 5!
Start the SpeediCut only after complete assembly and
inspection!
Move at least 10 ft. away from the place where you fueled
the SpeediCut.
Make sure you have a good footing, and place the SpeediCut
on the ground in such a way that the cutting disc is not
touching anything.
D
1
2
10 Feet
Turn the hood lock (2) to position and hold it there.
Pivot the hood (3) back as far as it will go.
Release the hood lock and pivot the hood lightly back and forth
until the lock engages.
2
3
E
Cold-starting
Move the combination switch (5) up (choke position).
Grasp handle [hand pressure actuates the grip throttle
lever lock (7)].
Push the throttle (8) in all the way and hold it.
Press the throttle lock (6) and release the throttle (8) (the
throttle lock will hold the throttle at half-throttle position).
Push the starting valve (4).
5
4
6
7
8
F
Grasp the tubular handle firmly with one hand and press the
SpeediCut against the ground.
Place the tip of your left foot in the rear handle.
Pull the starter cable strong and rapidly until you hear the first
audible ignition.
CAUTION: Do not pull out the starter cable more than approx.
20", and lead it back by hand.
Press in the starting valve (F/4) again.
Put the combination switch (F/5) in position “I”.
Keep pulling the starter cable until the engine catches.
As soon as the engine is running, press the throttle (F/8) to
release the half-throttle lock (F/6), allowing the engine to idle.
Warm-starting
As described under “Cold starting”, except without putting the
combination switch (F/5) in choke position.
G