Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 1.0.5
49
3.10
MSLCP & STLCP Resource Leakage
This release corrects a resource leakage issue encountered using the MSLCP
and STLCP commands where an internal message was not released. If the
commands were executed a large number of times this could result in internal
congestion and ultimately a system restart.
3.11
Per-Network Context Default Route
Previously only one default MTP or M3UA route could be specified on a
Signaling Server. This has been changed so one default route (MTP or M3UA)
can be specified per Network Context.
3.12
SS7MD – Sync Alarm (IPY00099685)
This release corrects an issue with the PCM Sync alarm when using CRC4
Multiframe Operation on the SS7MD board which previously resulted in failure
for the alarm to clear despite the PCM signal being valid.
3.13
PCM – Bit Errors and Code Violations
Two additional PCM Measurements are now reported; BITERR is the count of
bit errors detected by the framer and CV is the count of line code violations.
3.14
INAP_FE command
The INAP_FE command now supports the configuration of functional entities
for both local and remote subsystems.
3.15
ISUP - German National Variant
This release corrects the coding of three optional German ISUP parameters
used in the Initial Address Message (IAM). Previously the NP.FF was defined
with wrong length and the NP.SSP and NP.UKK parameters were assigned the
wrong parameter value.
3.16
SCCP – Disable UDTS Generation
An option has been introduced to allow automatic generation of UDTS
messages by SCCP to be disabled. Further details are available on request.
3.17
M2PA - Dynamic Configuration
Previously issues existed where a user was unable to deactivate an SS7 M2PA
link, dynamically add a TDM with the same blink as an existing M2PA link
(which identifies the SIGTRAN link id for M2PA) as well as not being able to
re-add a previously removed SS7 M2PA link. These have been corrected.
3.18
M3UA – Default Trace Mask
To improve usability the MMI command CNTMS has been modified to offer
default values for the input and output trace masks that allow tracing RX_IND
and TX_REQ messages without needing to explicitly set the trace masks.
Dialogic
27-Apr-12
