Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 2.2.3
25
3.4
Restart Error
Reporting of the “Restart Error” alarm has been changed so that instead of
multiple “Restart Alarm” events being generated the unit will now generate a
single “Parse Error” alarm. Further information on the cause of the error is
now available on page 2 of the active alarm list.
When the unit fails to start up correctly (indicated by “Config fail” or “Parse
errors” alarms) the unit will actively prevent dynamic configuration changes.
The user must correct the configuration issues and restart the unit.
3.5
MNRSI Command (IPY00115903)
This release corrects an issue with the operation of the MNRSI command
which previously failed to execute correctly if a second user was logged on
and executed a command shortly after MNRSI was executed.
3.6
MSSYP Command (IPY00115914)
This release allows the overload count (NOVLD) to be optionally reset by
using RESET=Y when executing the MSSYP command.
3.7
MSSLP Command
This release corrects operation of the MSSLP command to prevent it causing a
restart. Previously an internal race condition could occasionally result in the
unit restarting, especially when operating under extreme overload conditions.
3.8
MSSTP Command (IPY00115902)
This release corrects the value of the measurement period for the MSSTP
command which previously was a smaller value than it should be. In addition
the TBUSY and TCONG parameters on page 2 of the MSSLP command have
been corrected to display duration in seconds (rather than tenths of a
second).
3.9
SS7MD Board Operation
This release corrects an issue introduced in Release 1.3.6 that resulted in
possible failures of the link to come back in service if it was manually
deactivated and then activated.
3.10
MTP3 - Dual Operation with Discrimination Disabled
This release corrects the processing of messages received on the partner link
set when point code discrimination is disabled to ensure that messages are
sent to the network (rather than the user) whenever an MTP_ROUTE to the
DPC is defined.
3.11
SCCP – Event Report Limiting
To avoid excessive reporting of identical SCCP Maintenance Events
(SCP_MSG_MAINT_IND) and Software Events (SCP_MSG_ERROR_IND), the
unit now issues a maximum of 10 event indications for any given event type
over any one minute interval. Further events during the interval are
suppressed.
