Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 1.0.5
47
Release 1.0.5
1
Overview
This is a maintenance release which includes several important corrections as
detailed below. All users are advised to upgrade to this release which is the
first generally available release since 1.0.2.
This release is fully backwards compatible with the previous release.
1.1
Applicability
All users are advised to upgrade to this release.
Additionally SNMP users are advised to upgrade to SNMP MIB package V2.02
or later.
The following user documentation updates are available for use in conjunction
with this release:
Dialogic
®
DSI Signaling Servers – SS7G41 Hardware Manual, Issue 2,
Dialogic
®
DSI Signaling Servers – SS7G41 Operators Manual, Issue 3,
Dialogic
®
DSI Signaling Servers – SS7G41 SIU Developers Manual, Issue 3,
Dialogic
®
DSI Signaling Servers – SNMP User Manual, Issue 3.
1.2
Resolved Customer Issues
The following customer issues are resolved in this release: IPY00099654 and
IPY00099685.
2
New Functionality
2.1
Message Based Link Set Selection
This release provides the ability to select (on a message by message basis)
which outgoing link set is used for MTP-TRANSFER-REQ messages. This is
different to normal MTP3 operation where selection of an outgoing route is
based on the Destination Point Code (DPC) contained within the message.
This functionality is targeted at a specific customer requirement. Further
details are available on request.
3
Other Changes
3.1
Ethernet Port Bonding (IPY00099654)
This release corrects an issue which arose when using Ethernet port bonding
to bond Ethernet port 1 with Ethernet port 0. Under these conditions if the
unit was restarted it would revert to a condition where it needed to be
manually reconfigured into SIU mode.
The release also simplifies the status for bonded Ethernet ports by the STEPP
MMI command. Instead of reporting ACTIVE/STANDBY/DOWN the status is
now either UP or DOWN.
3.2
Serial Number Display
The CNSYP MMI command has been enhanced to display the serial number of
the unit using the UNIT_SERIAL parameter.