Dhollandia DH-SM, Руководство по установке

Страница: 27 / 69

26
DHOLLANDIA
11 MOUNTING OF THE PLATFORM
•
Connect the battery and ground cables of the liftgate to the power source [see chapter 14] to enable easy manipulation of the hydraulic
cylinders and hydromotor.
CAUTION
•
The hydraulic cylinders and circuits might contain air. The piston rods might slide out with shocks when the cylinders are filled with
oil.
•
The installer must consult and follow the DHOLLANDIA safety instructions for maintenance and repair. Negligence can lead to
serious personal injury.
•
In case of doubt, contact the national DHOLLANDIA distributor for further advice.
•
Position the lift frame is in the rearmost third of the slide tubes. Ensure the rollers of the slide plates don’t come out of the rear end of
the slide tubes. [Figure 11.1]
•
Dismount the 4 pivot pins (2 for the lift arms L+R, 2 for the tilt cylinders L+R), their locking bolts and the platform rollers from the
platform.
•
Raise the platform safely (by hoist, overhead gantry crane, fork lift etc.) and bring the brackets for the lift arms on the platform [1]
above the lift arms themselves [2]. [Figure 11.2].
WARNING
•
The platform is very heavy! When falling on a person, it
can cause serious personal injuries or death.
•
Therefore, apply maximum care and use duly serviced
lifting equipment to raise the platform in the air and
move it into position.
•
Make sure that nobody stands or sits under or within
reach of the suspended platform.
Figure 11.1
Figure 11.2