DFI 686IPK, Руководство пользователя

Страница: 10 / 78

10
2. Remove the system unit cover. Refer to the manufacturer’s instruc-
tions if necessary.
3. Detach all connectors from the old system board and remove ex-
pansion cards seated in any expansion slots.
4. Loosen the screws holding the original system board and remove
the board from the system. Save the screws.
5. Remove the 686IPK from its original packing box. Be careful to
avoid touching all connectors and pins on the board. Refer to the
handling instructions on pages 8-9 for proper handling techniques.
6. Place the system board on a flat surface (not in a chassis) with the
component side facing up.
7. Install the retention mechanism that comes with the package. Refer
to the Installing the Retention Mechanism section for installation in-
structions.
8. You are now ready to install the Intel Pentium

II processor. Before
you install the processor, carefully read the installation instructions
under the Intel Pentium

II Processor Installation section.
Note:
Make sure the system board is not yet installed with any SIMMs,
add-in cards, cables, etc.
9. Insert the memory modules into the memory banks on the 686IPK. The
quantity and location of the memory modules depends on the
memory configuration and type of modules you intend to use.
10. Set the corresponding jumpers.
11. Install the prepared 686IPK system board into the case. Make sure
you install screws into the four mounting holes shown on the next
page.