DFI 686IPK, Руководство пользователя

Страница: 21 / 78

21
3. Slide the clip (A) on each support toward the processor, exposing
the hole that will fit over the peg on the system board. Push the
latches (B) on the processor toward the center of the processor
until they click into place.
4. Hold the processor so that the fan shroud is facing toward the pegs
on the system board. Slide the processor (C) into the Retention
Mechanism and slide the supports onto the pegs. Ensure that the
pegs on the system board slide into the holes in the heatsink sup-
port and that the alignment notch in the processor fits over the plug
in Slot 1. Push the processor down firmly, with even pressure on
both sides of the top, until it is seated.
5. Slide the clips on the supports (A) forward until they click into place
to hold the pegs securely. (Apply slight pressure on the peg and
push the peg toward the clip while pushing the clip forward.) Push
the latches on the processor (B) outward until they click into place
in the Retention Mechanism. The latches must be secured for
proper electrical connection of the processor.
6. Attach the small end of the power cable (C) to the three-pin con-
nector in the processor, then attach the large end to the three-pin
connector (J4 - fan connector) on the system board.