www.dfi.com
14
2. Grasp the module by its edges and align the memory’s notch with the socket’s
notch; then insert the memory into the socket at an angle and push it down until
you feel a click.
Notes:
1.
The system supports dual-channel configuration. To enable dual-channel,
populate both SODIMM sockets.
2.
The SODIMM sockets can only accept DDR4 memory modules. Please do not
install other types of memory modules.
SODIMM module
The system board is equipped with 2 Mini PCIe slots: one full-size (PCIe/USB signals) and one
half-size (USB/mSATA signals) slot. Here we will demonstrate the installation of a full-size Mini
PCIe card.
1.
Grasp the Mini PCIe card by its edges and align the notch in the connector of the Mini PCIe
card with the notch in the connector on the system board.
Installing a Mini PCIe or mSATA Card
0.82mm
Important:
The bottom side of a full-size Mini PCIe module should have a component height
restriction of 0.82 mm and will sit flush against the connected half-size Mini PCIe
module if such a component is used and the half-size slot is connected with a module.
