43
2
Hardware Installation
2.7.9 Wake-On-LAN Connector
The system board suppor ts the Wake-On-LAN function. This
function will allow the network to remotely power-on a Soft Power
Down (Soft-Off) PC. However, if your system is in the Suspend
mode, you can power-on the system only through an IRQ or DMA
interrupt.
Your LAN card package should include a cable. Connect one end of
the cable to the wakeup header on the card and the other end to
location J13 on the system board. The network will detect Magic
Packet and asser t a wakeup signal to power-up the system. Refer to
the add-in card’s manual for details. Note: Your LAN card must
support the remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥
720mA.
BIOS Setting
To use the Wake-On-LAN function, you must enable the “Wake Up
On LAN” (“Wake-Up Event Setup” field) in the Power Management
Setup of the BIOS.
1
3
WOL
Ground
+5VSB
