Dexter Laundry OPL 30 Cycle 200G Express, Руководство по запчастям и обслуживанию

Страница: 56 / 71

Machine Operation
Programmed temperatures will be displayed in CENTIGRADE only. The electric heaters will turn on when
low water level has been obtained and actual temperature is less than programmed temperature. While the
heaters are engaged the wheel will pause 3 minutes between each forward/ reverse rotation. The wheel
will resume normal operation when bath temperature is 5 degrees before the programmed temperature is
reached. Cycle countdown time display will stop while heaters are engaged. Heaters will maintain tempera-
ture throughout heated baths and will engage when bath temperature drops below 3 degrees of programmed
temperature. Actual temperature may be displayed by pressing the start and down arrows simultaneously.
The temperature light will be on whenever the temperature is being displayed and will continue to be dis-
played until the start button is pushed again to display time remaining.
Any temperature between 20 degrees and 90 degrees in 5 degree increments is programmable. Any bath
that has a programmed spin cycle will go through a short cool down bath before spinning if the actual bath
temperature at the time of draining is above 65 degrees . This bath consists of filling tub to low level with
WARM water while tumbling and then draining. This will continue until bath temperature is below 65 degrees
If machine stop button is pressed momentarily( soak condition) while the heaters are energized, the wheel
will continue with the 3 minute pause between each forward / reverse rotation until the set temperature has
been reached. The normal 15 minute pause between each forward/reverse rotation will then take place until
the start button is pushed to resume the cycle. Actual bath water temperatures will normally overshoot the
set temperature by 1degrees to 3 degrees . This is to assure set temperature will be maintained throughout a
normal bath time of 10-20 minutes. The heaters will engage if the bath temperature drops below 3 degrees of
set temperature.
Heated Machine Programming
The heated bath is programmed in our water temperature selection portion of our microprocessor. You will
program a formula the same way as perviouslly discussed in this manual except as follows:
When you arrive at temperature selection portion of programming you will see the following choices :EE (tub
mpty),CC (cold), CH (warm), HH (hot), or any temperature between 20 degrees and 90 degrees in 5 degrees
increments. Use the up arrow and down arrow pad to set the water temperature desired (Centigrade) and
then push the green start button to accept the change and then move to the next programming sequence.
Continue with any other cycle changes as previouslly discussed.
To exit the program mode and accept all changes press the red stop button while any one of the nine bath
lights( top row of lights) are lit. The” Select cycle “ light should be on. Turn the run/program key back to run
position. If the program mode is exited incorrectly, the “Program” light will remain lit and the machine will re-
main in the program mode until the run/program key is turned back to the program position and the program
is exited correctly.
Features
When a numeric value for temperature is programmed for any bath the water valve selection to fill that
bath is chosen as follows:
20 degrees - 35 degrees Centigrade Cold valve only will be used
40 degrees - 60 degrees Centigrade Cold and Hot Valve will be used
65 degrees - 90 degrees Centigrade Hot valve only will be used
The machine will have 6 or 9 heating elements The temperature control and display are operated with a
temperature control circuit board on the I/O board, a thermistor sensor in the tub back, and a computor
logic board (CPU).
Part # 8533-096-001 11/16
Part # 8533-096-001 11/16
110 111
Section 7:
Electric Heated
Models