DeWalt DCST970, Инструкция по эксплуатации

Страница: 12 / 40

English
10
12. Line up the white nubs 22 inside the spool housing
with the recesses
28
of the spool. Align the holding
slots 24 with the two holes 27 as close as possible.
13. Push the spool into the spool housing and turn
counterclockwise to lock the spool in place. Ensure the
white nub
22
appears in the spool window
21
. Make
sure the line doesn't unravel and wrap around the shaft
below the spool.
14. Pull both ends of the cutting line to release them from
the holding slots. If the line extends past the cutting blade
on the guard cut the line so it just reaches the blade.
fig. M
27
22
28
Replacing Spool Housing (Fig. N, O)
1. Rotate the spool housing
11
until the hole
29
in the
spindle 30 lines up with notch 31 in the guard 10 .
A third hole in the motor housing 32 will be visible as
shown in figure N. Insert screwdriver through each all
three holes to prevent the spool housing from turning.
2. Turn the spool housing clockwise as shown in figure O.
3. Insert a screwdriver back through the three holes
( 29 , 31 , and 32 ) and thread the new spool housing
counterclockwise and securely tighten onto the bolt 33
protruding from the trimmer.
fig. N
30
29
32
31
fig. O
33
Replacing Guard (Fig. P, Q)
WARNING: Never operate appliance without guard
firmly in place. Damage or personal injury could result.
1. Remove the spool housing as described in the
"Replacing Spool Housing" section.
2. Remove the 4 guard screws 34 shown in figure P.
3. Lift the guard off at an angle as shown in figure Q.
fig. P
34
34
fig. Q
4. To attached a new guard, slide the tab
35
of the new
guard under the lip 36 of the motor housing 6 , then
lower the back of the guard into place as shown in
figure R.
5. Replace and securely tighten the 4 guard screws
34
.
6. Replace the spool housing as described in the
"Replacing Spool Housing" section.
fig. R
36
35
Repairs
The charger and battery pack are not serviceable.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
D
e
WALT factory service center
or a D
e
WALT authorized service center. Always use
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.