
SERIES 40 ENGINE OPERATOR'S GUIDE
Figure 26 Fuel Pro 382E Fuel
Processor Assembly
Replace the element as follows:
1. Shut down the engine and allow
it to cool.
2. With the engine at ambient
temperature and cool to the touch,
place a suitable container under
the
fi
lter.
3. A fuel shutoff valve may be
installed on the discharge side of
the fuel
fi
lter. If installed, turn the
handle on the shutoff valve to the
closed
position (perpendicular to
the valve).
4. Open the drain valve at the base
of the fuel processor and drain the
fuel until it is below the bottom
of the
fi
lter in the see-thru cover.
Close the drain valve. The fuel
may be returned to the tank.
5. Using
fi
lter collar/vent cap
wrench part number 232002 or
equivalent, remove the collar
by turning counter-clockwise.
Remove the cover,
fi
lter spring
and cover seal ring by lifting
straight up and over the
fi
lter
element.
6. Remove the element from the
center stud (fuel outlet pipe)
by pulling upward and twisting
slightly.
NOTE:
Current filter elements include an
integral sealing grommet. If a former
element is replaced, make sure the
separate sealing grommet is removed
from the center stud before installing
the new element.
7. Dispose of the used element and
grommet in an environmentally
responsible manner, according
to federal (EPA) and/or state
recommendations.
8. Check to make sure the sealing
grommet is included in the base
All information subject to change without notice.
(Rev. May 2004)
85
DDC-SVC-MAN-0057 0305
Copyright © 2003 DETROIT DIESEL CORPORATION