Part Number
Issue
Date
Page
6159937790
12
03/2018
99 / 184
99 (184)
03/2018
Drag Torque results
:
-
Once the
Prevailing max angle
is reached, if the
Drag torque
does not exceed the prevailing
torque limits the strategy will continue in the second phase.
-
If the
Drag torque
goes over the configured prevailing limits, this first step fails and the strategy
will end with a NOK result.
The Delta Wrench display background is colored as follows:
Blue
Default color used for Pset execution.
Green
The display turns green if the test ends with OK result.
Red
Torque and/or angle over the maximum limits
.
The buzzer is activated as follows:
Buzzer
The beep emitted by the buzzer starts when the torque goes over the
Cycle
Start
value, and it increases its signal when approaching the target.
At the end of the tightening operation three more beeps inform the operator of
the end of the operation; if the result is NOK, the beep is repeated at high
frequency to indicate the error.
•
Torque and Angle phase
: the second stage of the strategy behaves like a
Torque & Angle
strategy, where a desired
Target torque
must be reached within a specific angle interval.
The displayed torque is the
torque peak
+/-
Drag torque
, depending on the compensation
option selected in the Pset.
The second progress bar indicates the approach to the
Final Target Torque
.
The torque values stored for the trace are the actual torque values, without considering the
value of the Drag Torque.
Results
:
-
If the
Final target torque
(torque peak +/-
Drag torque
) does not exceed the limits during the
specified angle interval, the result will be OK.
-
If the
Final target torque
(torque peak +/-
Drag torque
) goes over the limits during the specified
angle interval, the second phase of the strategy will end with a NOK result.
The Delta Wrench display background is colored as follows:
Blue
Default color used for Pset execution.
Green
The display turns green if the test ends with OK result.
Red
Torque and/or angle over the maximum limits
.