22
102652
INSTALLING
Continued
4. Place the crossover log (#5) on the back log and the top middle log. Make sure the peg
on the rear log is in the hole in the bottom of the crossover log. The crossover log
should fit in the cutout of the top middle log (see Figure 25).
Figure 25 - Installing Crossover Log (#5)
Crossover
Log (#4)
Hole
Peg
Cutout
OPERATING
HEATER
Thermostat-
Controlled Models
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING ICON
G 001
WARNING
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell
next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the
knob will not push in or turn by hand, don’t try to repair it, call a qualified service
technician or gas supplier. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water. Immediately call a
qualified service technician to inspect the appliance and to replace any part of the
control system and any gas control which has been under water.
