20
102652
Right Front
Branch (#5)
Notches
Left Front Branch (#4)
(24" & 30" models)
or Front Branch (#4)
(18" Model)
Notches
INSTALLING
Continued
WARNING ICON
G 001
WARNING
Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when
installing. It is very important to install these logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Slide rear log (#1) into place behind rear burner (see Figure 17).
2. Slide front log (#2) into place behind front burner. Make sure tabs at bottom of log are
behind front burner (see Figure 18).
3. Place crossover log (#3) into place (see Figure 19). Be sure to place back of crossover
log into notch on left side of rear log. The indentation under front right fork of cross-
over log must rest on rectangular knob of front log.
4. Place left front branch (#4) and right front branch (#5) (24" and 30" models) or front branch
(#4) (18" model) into place (see Figure 20). Make sure notches on bottom rest on grates.
5. Add lava rock around base of heater.
INSTALLING LOGS (Standard Oak Design Models)
Figure 17 - Installing Rear Log
Rear Log
(#1)
Crossover
Log (#3)
Figure 19 - Installing Crossover Log
Figure 20 - Installing Left Front
Branch and Right Front Branch
Figure 18 - Installing Front Log
Tab
Front Log
(#2)
