www.desatech.com
110882-01K
17
INSTALLING OPTIONAL REMOTE
ACCESSORIES
Installing Remote Receiver Unit
1. Disconnect switch wires from the control
valve.
2. Remove screws and nuts.
3. Remove switch plate (see Figure 21). Discard
after removing.
4. Install remote receiver unit onto gas log
heater base using clips (2) and insulating
washers provided.
5. Push clips firmly into place (see Figure 22).
6. Connect wires as shown in Figure 23.
Note:
On yellow flame models, reuse provided
phillips head screws and reinstall heat shield over
receiving unit.
Figure 21 - Switch Plate and Wiring
Harness (Switch Plate and Orientation
May Vary Depending On Model)
Figure 23 - Connecting Wires
Valve
Red Wire
From Receiver
Figure 22 - Installing Remote Receiver
Front
Back
Insulating
Washers
Remote
Receiver
Mounting
Clips
Front
Back
Wires
Nut
Nut
Screw
White Wire
From Receiver
INSTALLATION
Continued
Front
Back
INSTALLING WIRELESS REMOTE
CONTROL ACCESSORY
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand held remote control set. One battery must be
installed in the receiver and one in the hand-held
remote control unit.
Note:
Only use alkaline
batteries.
Installing 9-Volt Battery (Not Included) in
Receiver
1. Locate back of receiver under front burner of
heater (see Figure 24).
2. Locate the battery clip mounted on the back
of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Figure 24 - Installing Receiver on the
Back of the Base
Battery Clip
9-Volt Battery
Receiver
Terminal Wires
Back
Front
