www.desatech.com
110882-01K
25
OPERATING HEATER
Continued
O
FF
P
ILO
T
LO
IH
ON
OFF
REMOTE
O
N
Selector Toggle Switch (Optional
Hand-Held Remote Control)
Control Knob
in On Position
Flame
Adjustment Knob
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions
, page 23.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through 11,
Lighting Instructions
, column 1, page 24.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note:
All remote control accessories must be
purchased separately (see
Accessories,
page
42). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions
on page 23.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be
-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 36).
Note:
The burner may light if hand-held remote was
on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Figure 36 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 37).
TO LOCk
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCk
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Figure 37 - On/Off Hand-Held Remote
Control Unit (HRC100)
Control Button
Turns Burners
On and Off
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using ei-
ther the manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 38, page 26). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace.
