www.desatech.com
110882-01K
13
1. Apply pipe joint sealant lightly to male
threads of gas fitting (not provided). For
Variable Manually-Controlled and Ther
-
mostatically-Controlled Models connect
approved flexible gas hose to gas regulator
of heater (see Figure 11). For Remote-Ready
models connect approved flexible gas hose
to inlet side of gas control (see Figure 12).
IMPORTANT:
Hold gas regulator with
wrench when connecting flexible gas hose
(Variable Manually-Controlled and Thermo
-
statically-Controlled Models Only).
2. Locate mounting brackets, bolts and nuts in
hardware package (Variable Manually-Con
-
trolled and Thermostatically-Controlled Models
Only). Attach mounting brackets to heater base
(see Figure 13). Attach nuts finger tight.
3. Position heater base assembly in fireplace.
4. For Variable Manually-Controlled and Ther
-
mostatically-Controlled Models mark screw
locations through holes in mounting brackets
(see Figure 13). For Remote-Ready Models
mark screw locations through holes in front
panel of base (see Figure 14). If installing in a
brick-bottom fireplace, mark screw locations
in mortar joint of bricks.
INSTALLATION
Continued
Heater Gas Regulator
Flexible Gas Hose
(if allowed by local
codes)
Figure 11 - Attaching Flexible Gas
Hose to Heater Gas Regulator
(Variable Manually-Controlled and
Thermostatically-Controlled Models Only)
Figure 12 - Attaching Flexible Gas Hose
to Heater Gas Regulator (Remote-Ready
Models Only)
Gas Control
Flexible Gas Hose
(if allowed by local
codes)
5. Remove heater base from fireplace.
6. Remove mounting brackets from heater base
(Variable Manually-Controlled and Thermo
-
statically-Controlled Models Only).
7. Drill holes at marked locations using 3/16"
drill bit.
8. For Variable Manually-Controlled and
Thermostatically-Controlled Models attach
mounting brackets to fireplace floor using
masonry screws provided in hardware pack
-
age (see Figure 13). Reattach heater base to
mounting brackets (see Figure 13). Tighten
nuts firmly.
9. For Remote-Ready Models attach base,
through holes in front panel of base, to fire
-
place floor using masonry screws provided in
hardware package (see Figure 14).
10. Connect to gas supply. See
Connecting To Gas
Supply
, page 14.
Figure 13 - Attaching Heater to Fireplace
Floor (Variable Manually-Controlled and
Thermostatically-Controlled Models Only)
Masonry
Screw
Mounting
Bracket
Screw
Mounting
Bracket Nut
Mounting
Bracket
Figure 14 - Attaching Base to Fireplace
Floor (Remote-Ready Models Only)
Masonry Screw
