www.desatech.com
123639-01D
18
INSTALLATION
Continued
Figure 20 - Installing Log #4
Figure 21 - Installing Log #5 (Right) and
Log #6 (Left)
Log #5
Log #6
Log #4
Log #3
Log #1
Log #2
Log #4
Log #3
Log #1
Log #2
ATTACHING GRATE TO BASE
ASSEMBLY
Locate the two slots in the front of the base
assembly. Carefully slide the decorative grate
into these slots (see Figure 22).
Figure 22 - Attaching Grate to Base
Assembly (Logs and Base Will Vary
According to Model)
Grate
Slots in Base
ADDING LAVA ROCK
Place lava rock around base of heater if de-
sired. Be sure not to cover the control knobs
or air inlet openings on the front of heater.
4. Place log #4 onto two alignment screws
to the rear of base (see Figure 20).
5. Place back of log #5 on notch in log #4 (as
shown in Figure 21), across back part of
log #1 and onto pin on log #2 (see Figure
19, page 18 and Figure 21).
6. Place log #6 onto two pins on log #1
(ember bed) and rest back of log #6 on
back log #4 (see Figure 21).
