Denzel 26601, Руководство пользователя

Страница: 10 / 28

9
ROTARY HAMMER
EN
be used for a long time and you have no need to replace or add grease. After the first start change lubrication
every 6 months of operation.
•
Clean the tool holder box every time after use.
•
In case of any damage to the power cable turn off the Electrical Rotary Hammer immediately, carefully, without
touching the places of damage, disconnect it from the mains.
ATTENTION!
Electrical Rotary Hammers use power cord with mounting type Y: for security it must be replaced by
authorized repair shop personnel.
Possible faults
Fault Probable cause Problem solution
When turning on the Electrical Rotary
Hammer there is no impact or rotation
of the tool.
Damaged gear or impact mechanism. Call the service center.
At turning on the electric motor does
not work (line voltage available).
Damaged switch or plug.
Call the service center. Broken power cord or mounting wire.
Brush or collector damage.
Circular fire on the collector.
Damage in the rotor winding.
Call the service center.
Wearout /”hang” of brushes.
Increased noise in the gear or impact
mechanism. Wearout/breakage of the mechanism
parts.
Call the service center.
When working smoke or smell of
burning insulation goes out from the
vent.
Interturn closure of rotor or stator
windings.
Call the service center.
Malfunction of the electrical part of
the instrument.
Tooling is not fixed or not extracted
from the box.
Damaged device of the tooling mount. Call the service center.
The use of low-quality tooling.
Use high-quality
tooling.
STORAGE
During the assigned service life store Electrical Rotary Hammer in a dry heated room. Recommended storage
temperature is from 0 °C to + 40 °C. Store Electrical Rotary Hammer in the original packaging.
Before placing the Electrical Rotary Hammer in storage remove the working tool.
TRANSPORTATION
During the transportation direct exposure of precipitation, direct sunlight, heat and shock is not allowed.
Transportation should be carried out only in the original packaging at temperature from - 20 °С to + 40 °С .
WARRANTY OBLIGATIONS
The product is covered by the manufacturer’s warranty.
The warranty period is specified in the warranty card and calculated from the date of sale. Terms of warranty
service are given in the warranty card.