Dentsply Sirona inEos X5, Руководство по эксплуатации

Страница: 38 / 56

9 Performing 3D acquisition
9.1 General Dentsply Sirona
Operating Instructions inEos X5
38
64 17 096 D3586
D3586.201.01.11.02 07.2018
Complete Reconstruction
For this option, the complete model is calculated with the palate/model
plate area. This option increases the calculation time for the model.
Reduced Reconstruction
For this option, the model is calculated as a dental arch without the
palate/model plate area. This option reduces the calculation time for the
model.
Tip: Select "Reduced Reconstruction" for all work which does not
involve the palate areas, or if areas of the model plate were also
scanned. This also helps to speed up the model calculation process.
Changing the standard settings of the model options
You can change the standard value of the reconstruction model in the
global settings from
"Complete" to "Reduced".
For all future cases, the reconstruction mode set as the default in each
case is selected in each image catalog. However, this can be adjusted
separately at any time.
The mode can be changed under
"Configuration" / "Devices" / "inEos
X5" / "Configure Device". You can activate the respective mode in the
"Standard Mode for model calculation" field.
9.1.5 Scan models and impressions
Materials
You can scan all materials that correspond to the following criteria:
● Non-reflecting
● Non-transparent
● No transparent parts
● Not highly absorbent
(e.g. heavily colored plasters, scannable impression materials)
IMPORTANT
Unscannable materials generate artifacts or gaps in the image.
Tip: When using materials that do not meet these criteria, you must
powder the affected areas. Otherwise the measuring accuracy will be
heavily influenced.
The following is suitable for this purpose, for example: CEREC
Optispray (REF 61 44 179)
For scanning with inEos scanners, we recommend using
CEREC Stone BC plaster (REF 62 37 502).