Denso BHT-1306B, Руководство пользователя

Страница: 24 / 256

12
BHT-1300B Series
2.1 “BHT Preparation” Procedure
Follow the steps below to prepare the BHT for use.
2.2 Loading and Charging the Battery
Cartridge (Page 14)
First load and charge the battery cartridge.
2.3 Attaching the Hand Strap
(Page 20)
Attach the hand strap to prevent the BHT from being
dropped.
2.4 Initial Setup
(Page 21)
Set the calendar clock when the power is turned ON for
the first time.
2.2 Loading and Charging the Battery Cartridge
The battery cartridge is not charged when purchased and should therefore be charged prior to use.
The chargers that can be use with the BHT are the communication units (CU-1301, CU-1311 and CU-1321) and
battery chargers (CH-201A*, CH-1104* and CH-1354).
* The CH-201A and CH-1104 chargers are used for charging individual batteries.
The charging time is approximately 3 hours to charge the BT-20LB and 2 hours to charge the BT-130LA.

If the power is supplied via the CU-1321 from the device connected to the USB port, charging takes approximately
7 hours for the BT-20LB and 4 hours for the BT-130LA.

An only slightly discharged battery cartridge should take less time to become fully charged.
Charging Precautions

Do not touch the BHT, battery, or charger terminals by hand or stain them. Doing so could result in a contact
failure or prevent charging.

Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger’s protective device, preventing from charging, and lead to protective
device damage, overheating, blowout or combustion.

Terminate charging if not completed even after the specified time has elapsed.

Do not use battery cartridges other than that specified by DENSO WAVE.