Dension ice-Link: Plus, Руководство по установке

Страница: 5 / 15

NOTE: Remove coax cable from amp (single pin cable left behind after changer removal and is still connected
to the amp … unplug it totally – Keep this cable stored with your changer in case you want to re-install…trust
me you won’t!
7. At this point you should have the DA Converter connected. Before we start running the harness to the front and
mount the cradle you need to make a DRY TEST RUN to see if the player works.
8. With the key out of the ignition re-connect the battery.
9. Now with everything lying in the trunk, carefully
remove the 15’ harness and carry it to the front driver’s
seat.
BE CAREFUL not to snag the harness on anything
or undo the work you’ve just completed.
10. Place the iPod in the Dension cradle, insert key and turn
to the 2
nd
position.
11. Turn the head unit on. If the head unit is not set to the c
changer -- switch to it.
NOTE: If the changer refuses to
come up and just displays TAPE temporarily -- STOP!
Turn the key to the off position and REMOVE the keys.
Go to the rear of the car and remove the 30A & 10A
fuses for the head unit and wait 5 minutes. Reconnect and try again.
d
12. Now you should see the player come to life. MAKE SURE YOU HAVE AT LEAST ONE PLAYLIST
SETUP. AFTER PLAYING AROUND UNPLUG THE 12v WIRE FROM THE CONVERTER.
13. Congratulations the easy part is done…GOOD JOB! Get some rest and rejuvenate the patience.
Look over the misc. photos below for reference on connections, etc. Now on to running the harness and trim/ panel
removal…