Dension ice-Link: Plus, Руководство по установке

Страница: 13 / 15

24. With the excess wired pulled, now route it down the
25. ust cut a hole in the carpet here (SEE RED
t
26. the cable you
he
7. Next remove the plastic threshold (NOT THE BMW
g
28. Unhook the carpet from the rear seat clips. Also,
le
t
9. Ok ENOUGH TALK…run that wire!
O TIGHT!
e).
30. Congratulations you’re almost home!
31. With the wire run now we can hook up the connectors and
drivers side of the console, adjacent to the air duct, to
the back of the console (Back to the rear ac vent
opening).
Now we m
ARROW IN PHOTO) and run the cable ONLY 18” to
make the connection. YEAH!
At this point I strongly
recommend a second person to help hold the carpet
back while the other fishes the wire through. I did no
have a person to help out and it cost me AT LEAST an
hour and a half of extra labor time.
To pull the carpet back enough to run
must first remove the side kick panels at each rear
passenger door. Take a 10mm socket and remove t
screw holding the kick panels and top of the rear seat. T
door opening about a foot off the sill. (SEE PHOTO – RED ARROW)
he screws are located at the bottom rear portion of the
2
SILL PLATE). Just pull up with some force, they
just snap in and out.
I broke a couple of mine durin
the process. Hopefully there not too expensive or
hard to replace?
now is a good time to unscrew the rear base conso
screw (driver’s side only). (SEE PHOTO – BLUE
ARROW) This will help out a lot when snaking tha
$%#($ wire.
2
IMPORTANT -- DO NOT PULL IT TO
Take it down the top left side of the center hump.
NOT ON TOP – Just off the top edge (driver’s sid
mount it to the center of the rear seat. NOTE: You do not
have a lot of extra slack coming from the cradle. I suggest
mounting the connector and wires the way I have them
shown 1.) To ensure no stress is put on the connectors /
wires and 2.) To protect them if the center seat is
occupied. (See Photo Below)