© by DENQBAR GmbH
http://www.denqbar.com
58
Use of alternating current (AC)
1. Turn on the device and check that the operating display lights up.
2. Ensure that the desired consumer is turned off and only then insert the power plug of the
consumer into the power socket.
Attention!
An overload of the generator, indicated by
OVER
in the field
P
of the operating display, may
damage the generator.
If the device shows abnormal action, for example slowed reaction or abrupt shut down, it must
be turned off immediately. Disconnect the consumer from the generator and check whether
the problem is caused by the consumer, or whether the rated power of the generator was
exceeded.
Use of direct current (DC)
1. Turn on the device and check that the operating display lights up.
2. Ensure that the desired consumer is turned off and only then connect the cable of the
consumer with the DC-socket.
NOTICE!
In DC operation (DC), turn the switch of the fuel economy mode into position "OFF".
Overload protection
230 V-socket:
the operating display lights up at normal operation
in case of overload it will be indicated by the command
OVER
in the field
P
of the operating
display
in case of overload turn the ignition key into position "STOP" and remove connected devices
afterwards restart the generator
Operating display
AC-power
outlet
