Denon DRA-700AE, Руководство по эксплуатации

Страница: 27 / 30

Operation Operation
24
ENGLISH
Remote control unit operations during multi-
source playback
Use
[FUNCTION]
to select the input source you wish
to output.
• The “ ” indicator and the indicator for the selected
source light.
The MULTI ZONE source switches directly.
When the MULTI ZONE SOURCE function is set to “TUNER”,
the preset channel can be selected pressing
[PRESET] .
2
Press
[ZONE2 (ZONE3) ON]
to turn on the zone power.
To cancel the ZONE2 or ZONE3 mode:
Press
[ZONE2 OFF] or [ZONE3 OFF] .
1
• When using ZONE2 or ZONE3, it is possible to turn the power for
the MAIN ZONE only on or off by pressing [MAIN ON/OFF] .
Recording (audio and/or video)
Press
<ZONE/REC SELECT>
until “RECOUT”
appears on the display.
Use
FUNCTION
to select the source to be recorded
(audio and/or video).
• The “ ” indicator lights.
1
2
• To cancel, press
<ZONE/REC SELECT>
and set the function to “ZONE”.
RECOUT
M-ZONE
Record (the audio or video signals).
For operations, see the operating instructions of the device from
which you are recording (audio or video signals).
3
NOTE:
• When the REC OUT mode is selected, [ZONE2 (ZONE3) ON] and
FUNCTION (ZONE) cannot be operated.
¢
Last function memory
The various settings set when the DRA-700AE/700AEDAB’s power is
switched to standby are stored in the memory. When the power is
turned back on, the settings made when the power was switched to
standby are recalled.
About the memory functions
¢
Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.
If the indication on the display is not normal or if the operation of the
unit is not correct, then the microprocessor should be reset by the
following procedure.
Switch off the unit using
<POWER>
.
1
Check that the entire display is flashing at 1-second
intervals and release the buttons.
• The microprocessor will be initialized.
3
Keep both
<SPEAKER>
(
A
and
B
) depressed and turn
on the unit by pressing
<POWER>
.
2
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from the
factory).
ENGLISH
Outputting a program source to amplifier, etc.,
in the ZONE2 (or ZONE3) room (ZONE2 or
ZONE3 SELECT mode)
Press
<ZONE/REC SELECT>
to select “M-ZONE”.
Use
FUNCTION
to select the source you want to
output appears on the display.
• The “ ” indicator and the indicator for the selected
source light.
1
2
• The signals of the source selected in the ZONE mode are also
output from the VCR and CD-R/TAPE recording output terminals.
RECOUT
M-ZONE
Start playing the source to be output.
For operating instructions, refer to the manuals of the respective
components.
3
The volume of the outputs of the different zones can
be adjusted with
[VOLUME]
.
Default volume setting
ZONE2/ZONE3 : – – – dB (Minimum)
The zone volume can be adjusted within the range of –80 to 18
dB, in steps of 0.5 dB.
3
Initialization of the microprocessor