60
3
Example: Stereo
Select the play mode.
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
MASTER VOLUME
The volume level is
displayed on the
master volume level
display.
(Main unit)
(Remote control unit)
The volume can be adjusted within the range of –80 to 0 to 18 dB,
in steps of 0.5 dB. However, when the channel level is set as
described on page 32~34 or pages 68 and 69 if the volume for any
channel is set at +0.5 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is “18 dB — (Maximum value of channel level)”.)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
Depending on the input signal.
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
The
indicator lights when digital signals are being input
properly. If the
indicator does not light, check whether the
digital input component setup (page 37) and connections are
correct and whether the component’s power is turned on.
AL24 processing is activated when PCM signals are played while
the surround mode is set to PURE DIRECT, DIRECT, STEREO.
DIG.
DIG.
NOTE:
• The
indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
DIG.
• In the EXT.IN mode
(Remote control unit)
(Main unit)
SELECT
To select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the
surround mode button then operate the selector.
(Main unit)
