Denon AVP-A1HDE, Руководство пользователя

Страница: 76 / 120

Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
MODE SELECTOR
Remote ID
AMP (MAIN) iPod
NET/DTU
(Net Audio)
1
(Default)
81001 72815 62865
2 82001 72816 62837
3 83001 72817 62838
4 84001 72818 62839
Setting the Remote ID
When using multiple DENON AV receivers in the same room,
make this setting so that only the desired AV receiver operates.
1
Press
[AMP]
to set the main remote control unit to the
AMP mode.
2
Press and hold in
[RC SETUP]
for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Refer to the table at the right, and use
[NUMBER]
to
input the 5-digit number corresponding to the remote
ID to be changed.
The signal transmission indicator flashes twice.
4
Press
[iPod]
or
[NET/DTU]
to select the mode to be
set.
5
Repeat steps 2 to 4 to set the remote IDs for all modes.
NOTE
• When changing a setting, be sure to set the same remote ID as the
AVP-A1HD’s ( v page 42).
• When changing the AMP mode’s remote ID, also change the “iPod”
and “NET/DTU” remote ID at the same time.
Learning Function
If your AV devices are of a brand other than DENON or if they
cannot be operated with the preset memory function, their
remote control signals can be transfered to stored in the AVP-
A1HD’s main remote control unit.
1
Press
[MODE SELECTOR]
for the device you want to
set.
2
Press and hold in
[RC SETUP]
for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press
[9]
,
[7]
and
[5]
, in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
4
Press the button to be set.
The main remote control unit’s display turns off.
b If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
5
Point the main remote control units directly at each
other and press and hold the button on the other
device’s remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
b
If you want to learn other buttons, repeat steps 4 and 5.
b
The mode can be switched by pressing
[MODE SELECTOR]
.
b
The signal transmission indicator lights once for a long time if
learning was not possible
6
Press and hold in
[RC SETUP]
for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
Other device’s
remote control unit
AVP-A1HD’s main remote
control unit (RC-1067)
Remot
e Contr
ol
[NUMBER]
[MODE SELECTOR]
[RC SETUP]
[ NET/DTU]
[ AMP]
[ iPod]
[SYSTEM CALL]
[POWER ON]
[HOME]
Signal transmission
indicator
[
8
], [
9
],
[
1
],
[
6
], [
7
],
[
3
], [
2
]