Denison Hydraulics Goldcup 6, Инструкция по установке и капитальному ремонту, Страница: 15 / 24

SECTION V – ASSEMBLY PROCEDURES
BARREL, ROCKER CAM
AND FLANGE ASSEMBLY
See Figure 4
1. Install tube line assemblies (3) and (4) in the holes provided in cradle.
2. Install two dowel pins (6) in the cradle mounting surface of the flange
and two dowel pins (6) in the outer edge of the flange.
3. Install rocker cam and cradle assembly over the two dowel pins (6)
in the mounting flange. Be certain that cradle is seated over the
pins and against the flange with the tube lines (3) and (4) in the
grooves in the flange.
4. Install two or more 1/4-20 x 1 1/4 screws through the seal retainer
area into the cradle. Be certain the cradle is fully seated in flange.
These screws are required to hold the rocker cam assembly in
and will be removed later.
5. Tilt the rocker cam to either extreme position in the cradle and position
the barrel assembly with auxiliary shaft (1) directly over the pistons.
Start with the upper-most piston and guide them one at a time into
the barrel. Return the rocker cam to a level position in the cradle.
NOTE: Tube assemblies (3 & 4) must be a snug fit into holes in
cradle. Expand end of tubes with a pointed tool to assure fit.
PARTS LIST FOR FIGURE 4
NO. QTY. PART NO. DESCRIPTION
1 1 See Fig. 2 Barrel and Hold-down Shaft Assy.
2 2 033-70524 Pressure Tube
3 1 S13-42402 Tubing Assy. (right side)
4 1 S13-42403 Tubing Assy. (left side)
5 1 See Fig. 3 Rocker Cam and Stroking Assembly
6 4 324-22412 Dowel Pin 3/8 x 3/4
7 1 033-70604 Mounting Flange
FIG. 5 s15-42335 HOUSING ASSEMBLY
NO. QTY. PART NO. DESCRIPTION
1 1 033-71284 Housing
2 1 033-70580 Bearing
3 4 324-21608 Dowel Pin
4 2 325-16280 Roll Pin
5 1 691-00912 O-ring 90-6290-12
6 1 488-35014 Hollow Hex Plug SAE-12
14